High Modulus Teflon Insulation Tape by Tenacious Tapes. Adhesive tape comparable to 3M PTFE Film Tape 5490, Nitto 903UL or Stylus DW204-3. Order online from exclusive approved supplier Wayout Evacuation Systems.
Colour: Beige
Roll Size: 6mm to 580mm in 10 Metre Lengths
Adhesive: Silicon
Description: P932 is manufactured from a high modulus PTFE film with high performance silicon adhesive. The 2 Mils carrier is consistent in dielectric strength at volts-per-mil. It is coupled with its outstanding thermal rating and conformability.
Application: For uses in coil, capacitor and wire harness insulation at high temperatures. UL recognised flame retardation.
Technical Details:
Tape Thickness: | 0.098mm |
Tensile Strength: | 47 N/cm |
Elongation at Break: | 120% |
Adhesion to Steel: | 3.5 N/cm |
Dielectric Strength: | 9.0kV |
Class of Insulation (UL510): | ULH/180°C |
Service Temperature: | -70°C to 260°C |
Surface Preparation: The surface on which the tape is to be used must be clean, dry and free from grease and dust. Remember that pressure sensitive adhesive must be applied with the maximum possible pressure in order to achieve maximum adhesion levels. The recommended application temperature is between 10ºC and 25ºC.
Storage: Tapes stored below the minimum application temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place.
Note:
The above figures represent average values. Actual figures can vary. The selection and
application of a tape is the responsibility of the buyer. Tape should be stored at room
temperature and should not be exposed to sunlight. We reserve the right to make changes
without notice to our products and specifications.